BAUMULLER鲍米乐伺服驱动器维修：2028No supply voltage at the device设备无电源电压。
In state transition from "Power-on Disable" to "Ready to Start", a three-phase supply is to be expected of the active mains rectifier on its terminals after closing the contact "Ready for Main Contactor ON" (X2-9; X2-10). 从“电源开启-禁用”到“准备启动”的状态转换三相电源应为有源主整流器闭合触点“准备主接触器”后的端子ON”（X2-9；X2-10）。
This error is triggered, if no three-phase supply is detected after closing the contact "Ready for Contactor ON" for 5 seconds. 如果在闭合触点“接触器接通准备就绪”5秒钟后未检测到三相电源，则会触发此错误。
This error cannot be cleared by the user.
用户无法清除此错误。
This error is reset by the device, if a three-phase supply is detected at the terminals of the active mains rectifier unit.
如果在有源主整流器单元的端子处检测到三相电源，则该错误将由设备重置。
BM3401-L1OOO-AEOOOCB-O控制器修理：
BAUMULLER DA180M54A17-5,63KW
BAUMULLER 电机SS90F-GNF80-L
BAUMULLER 电机BFN 3-1-270 275V
BAUMULLER 电机BUS6-VO-0E-0036
BAUMULLER 电机BUM64A-300/390-54-E-O-003
BAUMULLER 电机BM1413-01-00-01
BAUMULLER BM4462-Sl2-01343-030
BAUMULLER BM4423-Sl1-21300-0308-1
BAUMULLER BM4422-Sl1-21300-0308-1
BAUMULLER BM4424-SI1-21300-0308-1
BAUMULLER BM4445-Sl2-21300-0308-1
BAUMULLER BM4145-ST0-00300-03
BAUMULLER BM4462-Sl2-01343-030
BAUMULLER BM4423-Sl1-21300-0308-1
BAUMULLER BM4422-Sl1-21300-0308-1
BAUMULLER BM4424-SI1-21300-0308-1
BAUMULLER BM4445-Sl2-21300-0308-1
转载请注明出处：上海仰光电子科技专业伺服驱动器维修,伺服电机维修
本文链接：http://www.tlwyjt.net/fuwu/Services_Show21868.htm
伺服驱动器维修 伺服电机维修 触摸屏维修 变频器维修
电话：021-50157782
手机：13817011982 微信同号
邮箱：shygdzi@163.com
联系人：张工
网址：http://www.tlwyjt.net
【 我们确保修好测试好给客户�。。�！】
下一篇：没有了
